MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE 1. Spin-on Fuel Filter 5. Strainer Assembly 2. Air Bleed Screw 6. Strainer 3. Air Primer Pump 7. O-Ring 4. Fuel Strainer Header 8. Body Figure 17 Typical Fuel Filter and Strainer Installation NOTE: Filter change intervals may be shortened to conform with established preventive maintenance schedules, but should never be extended. no less than 60 psi (414 kPa) at normal operating speed. Change the fuel filters whenever the fuel pressure at the inlet fitting falls below this level. One method of determining when filters are plugged to the extent that they need replacing is based on the fuel pressure at the cylinder head fuel inlet fitting.

Fuel pressure should be All information subject to change without notice. (Rev. May 2004) 65 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION