LUBRICATION AND PREVENTIVE MAINTENANCE INTERVALS Fuel Pro® 382 Filters Install new Fuel Pro® 382 primary fuel filter elements when the fuel level in the see-thru cover reaches the top of the element or after one year of service, whichever comes first. Refer to section Replace “Fuel Pro® 382/382E” Fuel Filter Element. Item 12 – Water Pump and Coolant Inhibitor Element Water Pump 1. Spin-on Inhibitor Element 2. Filter Adaptor Water Pump Drain Hole – The water pump drain hole should be inspected every 6 months to make sure it is open. A small chemical build-up or streaking at the drain hole may occur. This is not an indication of a defective water pump or seal.
Remove the build-up with a mild detergent cleaner and a brush. If coolant does not leak from the drain hole under normal conditions, do not replace the water pump. Figure 18 Installing Coolant Inhibitor Element Required test intervals are listed in Table 28 . For SCA test procedures refer to section G. How to Select Coolant and then refer to section SCA Test Procedures in this guide. Use the coolant filter element required. Refer to section Power Cool Engine Products for element part number listing. The valves mounted on the filter adaptor head must be opened after the element is replaced.
Coolant Inhibitor Element The coolant must be tested at required intervals and the coolant inhibitor element replaced, if required. Item 13 – Cranking Motor For cranking motor (starter) assembly information, contact an authorized Delco Remy® distributor. 66 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION