SERIES 40 ENGINE OPERATOR'S GUIDE Item 14 – Air System Item 17 Radiator All the connections in the air system should be checked to make sure they are tight and leak free. Check all hoses and ducting for punctures, deterioration or other damage and replace, if necessary. The exterior of the radiator core should be inspected every 30,000 miles (48,000 km), 12 months, or 300 hours (stationary and industrial engines) and cleaned, if necessary. Item 15 – Exhaust System Have the exhaust manifold retaining bolts and other connections checked for tightness. Have the exhaust pipe rain cap checked for proper operation, if so equipped.
To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 40 psi (276 kPa) air pressure. Item 16 Engine (Steam Clean) Steam clean the engine and engine compartment every 60,000 miles (96,000 km) or 2,100 hours, whichever comes first. Steam clean more frequently, if operating in dusty or dirty environments. Use a quality grease solvent, such as mineral spirits, and dry with compressed air. Fuel oil, kerosene or gasoline should not be used. It may be necessary to clean the radiator more frequently if the engine is being operated in extremely dusty or dirty areas. NOTICE:
Do not apply steam or solvent directly to the battery-charging alternator, starting motor, electronic engine control components, sensors or other electrical components, as damage to electrical equipment may result. If the low coolant level sensor is installed in the top tank of the radiator, it should be tested for proper operation every 100,000 miles (160,000 km) or 12 months, whichever comes first. Authorized Detroit Diesel distributors are properly equipped to perform this service. All information subject to change without notice. (Rev. May 2004) 67 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION