MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE Disconnecting the battery can result in damage to the battery diodes. In applications which have two (2) sets of batteries, switching from one set to the other while the engine is running will momentarily disconnect the batteries. This can result in equipment damage. higher than 6 in. water (1.5 kPa) at maximum no-load speed with the breather restrictor tool installed. Item 22 Fan Hub The fan hub assembly includes a sealed bearing which is not serviceable. 4. If a booster battery is to be used, batteries must be connected correctly (negative to negative, positive to positive) to avoid equipment damage. Inspection Interval:

Inspect the fan hub for free bearing rotation at the interval shown in the regular maintenance interval table for your engine. If the hub does not spin freely or is noisy (indicating bearings are or worn), replace the fan hub. 5. Never use a fast charger with the batteries connected or as a booster for battery output. For information on the alternator assembly, contact an authorized Delco Remy® distributor. Replacement Interval: Replace the fan hub at the interval shown in the regular maintenance interval table for your engine, regardless of apparent condition.

Item 20 Engine and Transmission Mounts The engine and transmission mounting bolts and the condition of the mounting pads should be checked every 60,000 miles (96,000 km) or 600 hours. Tighten and/or repair as necessary. Item 21 Crankcase Pressure The crankcase pressure should be checked and recorded at the intervals in the maintenance schedules. Crankcase pressure should be no All information subject to change without notice. (Rev. May 2004) 69 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION