MAN — Man Series 40 Engine Operator's Guide

LUBRICATION AND PREVENTIVE MAINTENANCE INTERVALS Item 23 Thermostat and Seal on vehicle engines. On non-vehicle engines, replace the thermostat and seal every 4,000 hours or 24 months, whichever comes first. Item 24 Crankcase Breather The steel mesh breather pad in the valve cover/intake manifold should be removed and washed in clean fuel oil when the valve cover is removed for valve lash measurement and adjustment. These intervals are listed in Table 22. 1. Thermostat 3. Cylinder Head 2. Seal Item 25 – Engine Tune-Up Figure 19 Typical Thermostat Installation There is no scheduled interval for performing an engine tune-up.

However, the valve lash must be measured and, if necessary, adjusted at the regular intervals listed in Table 22. Replace the thermostat and seal every 240,000 miles (384,000 km) * Whichever comes first. Table 22 Valve Lash Measurement/Adjustment Schedule 70 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION Engine Application Valve Lash Measurement/ Adjustment Interval Motor Coach Every 60,000 Miles (96,000 km) or 24 Months* Transit Coach Every 45,000 Miles (72,000 km) or 18 Months* Stationary, Construction/Industrial, Agricultural, or Generator Set Engines Every 1,500 Hours or 45,000 Miles (72,000 km)*