MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE Item 26 – Idler Pulley The fan belt idler pulley requires periodic inspection and replacement. Inspection Interval: Inspect the idler pulley for free bearing rotation at 45,000 miles (72,000 km) on vehicle engines and at 450 hours on non-vehicle engines, or whenever the serpentine belt is removed. If the pulley does not spin freely or is noisy (indicating bearings are or worn), replace the pulley. Figure 20 Typical Rubber-Bushed Vibration Damper Replacement Interval: Replace the idler pulley every 60,000 miles (72,000 km) of operation on vehicle engines or every 9,000 hours of operation on non-vehicle engines, regardless of apparent condition.

Rubber-Bushed Damper: Inspect damper (see Figure 20) once a year. Replace if rubber “streaking” on the damper face exceeds guidelines (contact a DDC distributor for guidelines) or if deep splits appear in the rubber member. Deep splits can allow chunks of rubber to break off from the damper (“chunking”), affecting its balance and dampening efficiency. Item 27 – Vibration Damper All Series 40 engines use rubber-bushed vibration dampers, except generator sets, which use viscous dampers. Heat from normal engine operation will, over a period of time, cause the rubber member in the vibration damper to become brittle as it ages.

For this reason the vibration damper must be replaced at time of normal major engine overhaul, regardless of apparent condition. All information subject to change without notice. (Rev. May 2004) 71 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION