LUBRICATION AND PREVENTIVE MAINTENANCE INTERVALS Welding Precaution NOTICE: Failure to isolate the electronic engine control system components from high current flow can result in severe ECM (electronic control module) damage. To avoid damage to vehicle electronic components, disconnect both the positive (+) and the negative (-) battery cables prior to electric welding. Attach the welder's ground cable as close as possible to the joint being welded. If it is necessary to weld close to an electronic component, the component should be temporarily removed. Figure 21 Typical Viscous Vibration Damper Viscous Damper: Inspect damper ( see Figure 21) once a year. Replace if dented or leaking.
Heat from normal engine operation may, over a period of time, cause the fluid within the damper to break down and lose its dampening properties. For this reason the viscous damper must be replaced at time of normal major engine overhaul, regardless of apparent condition. Whenever welding is done on any part of the vehicle, the batteries must be disconnected, both power and ground, which must include all electronic power feeds. The electronic components may easily be damaged by the high voltage used and the RF (radio frequency) energy present in the arc. 72 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION