SERIES 40 ENGINE OPERATOR'S GUIDE B. When to Change Oil interval at which the engine may operate before the oil and filters must be changed is listed in Table 23. Oil analysis may be used to determine whether this interval should be shortened, but it should not be used to lengthen the interval. Oil Drain Intervals To avoid injury from contact with the contaminants in used engine oil, wear protective gloves and apron. The use of fuels with sulfur content above 0.05 mass percent will require a shortening of drain intervals and/or the use of a higher TBN oil. See the information listed in Table 23.
For detailed information refer to publication Engine Requirements – Lubricating Oil, Fuel and Filters (7SE270), available from authorized Detroit Diesel distributors. The length of time an engine may operate before an oil change depends upon the lubricant and fuel used, engine oil consumption, and the operating cycle. The maximum Table 23 Maximum Oil Drain and Filter Change Interval (Fuel Sulfur 0.05 Weight Percent or Less) All information subject to change without notice. (Rev.
May 2004) 75 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION Engine Application Drain Interval Motor Coach, City Transit Coach 12,000 Miles (19,200 km) Fire Truck or Crash/Rescue Vehicle 6,000 Miles (9,600 km), 300 Hours or 1 Year, whichever comes first Construction, Industrial or Agriculture 150 Hours, 4,500 Miles (7,200 km) or 1 year, whichever comes first Stationary Generator Set, Prime Power or Continuous 250 Hours or 3 Months, whichever comes first Stationary Generator Set, Standby 150 Hours or 1 Year, whichever comes first