MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE to federal (EPA) and/or state recommendations. See Figure . 5. Using a 29 mm or 1 1/8–in. deep socket, carefully remove the plastic fuel strainer cover. 1. Spin-on Fuel Filter 5. Strainer Assembly 2. Priming Pump 6. Strainer Element 3. Air Bleed Screw 7. Seal Ring 4. Fuel Strainer Header 8. See-Through Body Figure 25 Typical Fuel Filter and Strainer Installation 6. Inspect the strainer for damage or plugging and clean or replace, as required. Clean the cover. Replace the O-ring, if damaged. NOTE: Install the strainer into the cover with the open end toward the filter header. All information subject to change without notice. (Rev.

May 2004) 81 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION