HOW-TO SECTION Do not use tools to install the strainer and do not overtighten, since this could distort or crack the plastic cover, resulting in fuel leakage during engine operation. NOTICE: Failure to disconnect the CMP (camshaft position sensor) before priming the engine may allow the engine to start during priming, which could result in severe engine damage. NOTICE: 7. Insert the strainer into the cover with the open end facing UP. With the O-ring in place, install the strainer onto the header. Tighten securely by hand . 12. Refer to Prime the Fuel System and Start the Engine below before starting the engine. 8. Wipe the filter adaptor header with a clean, lint-free cloth.
Prime the Fuel System and Start the Engine 9. Fill the new replacement filter with clean diesel fuel and coat the gasket lightly with the fuel. NOTICE: Failure to disconnect the CMP (camshaft position sensor) before priming the engine may allow the engine to start during priming, which could result in severe engine damage. 10. Thread the new filter onto the adaptor insert until the gasket makes full contact with the adaptor header and no side movement is evident. Tighten filter an additional one-half turn by hand, or as indicated on the filter. Prime the fuel system as follows: NOTICE: Do not overtighten the filter. Overtightening may crack or distort the adaptor head. 11.
If previously closed, open the fuel shutoff valve. 82 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION