MAN — Man Series 40 Engine Operator's Guide

HOW-TO SECTION of the replacement filter element, then install the element onto the center stud by pushing down and twisting slightly. To avoid cover or vent cap damage, do not use tools to tighten the vent cap. NOTICE: 9. Check to make sure the spring is installed at the top of the cover. If missing, this spring must be replaced to insure proper filter operation. Wipe the cover lip and cover seal clean. 12. Open the fuel shutoff valve (if equipped). 13. The fuel system must be primed before starting the engine. Refer to section Prime the Fuel System and Start the Engine. NOTICE:

Do not use a wrench of any kind to tighten the collar, since this may lead to overtightening, which can damage the collar and/or the cover. 14. After starting the engine, allow the lubrication system to reach its normal operating pressure, then increase engine speed to high idle for 2 to 3 minutes. 10. After making sure the seal is properly positioned at the base of the cover, install the cover and collar onto the fuel processor. Tighten the collar by hand until secure. Do not allow the fuel level in the see-thru cover to fall below the top of the collar, since this may lead to interruption of the fuel flow and engine stalling. NOTICE: 11.

Using filter collar/vent cap wrench 232002 or equivalent, remove the vent cap from the top of the cover by turning the cap counter-clockwise. Fill the cover full of clean fuel. After making sure the O-ring seal is installed on the vent cap, reinstall the cap and tighten by hand . 15. After the air is purged and with the engine still running, loosen the vent cap. The fuel level in the cover will start falling. When the fuel level falls to the top of the collar, tighten the vent cap quickly by hand . 16. Shut down the engine and tighten the collar again by hand . 86 All information subject to change without notice. (Rev.

May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION