MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE closed position (perpendicular to the valve). 4. Open the drain valve at the base of the fuel processor and drain the fuel until it is below the bottom of the filter in the see-thru cover. Close the drain valve. The fuel may be returned to the tank. 5. Using filter collar/vent cap wrench part number 232002 or equivalent, remove the collar by turning counter-clockwise. Remove the cover, filter spring and cover seal ring by lifting straight up and over the filter element. 6. Remove the element from the center stud (fuel outlet pipe) by pulling upward and twisting slightly. Figure 26 Fuel Pro 382E Fuel Processor Assembly NOTE:

Current filter elements include an integral sealing grommet. If a former element is replaced, make sure the separate sealing grommet is removed from the center stud before installing the new element. Replace the element as follows: 1. Shut down the engine and allow it to cool. 2. With the engine at ambient temperature and cool to the touch, place a suitable container under the filter. 7. Dispose of the used element and grommet in an environmentally responsible manner, according to federal (EPA) and/or state recommendations. 3. A fuel shutoff valve may be installed on the discharge side of the fuel filter. If installed, turn the handle on the shutoff valve to the 8.

Check to make sure the sealing grommet is included in the base All information subject to change without notice. (Rev. May 2004) 85 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION