HOW-TO SECTION Replace Fuel/Water Separator Element To avoid damaging the bowl or the filter, do not use tools when tightening. NOTICE: If an optional primary filter/water separator is installed in the fuel system piping, replace the element as follows: 1. Shut down the engine and allow it to cool. 8. Apply a light coating of clean fuel oil or grease to the new O-ring seal on the top of the replacement filter. Thread the filter and bowl assembly onto the filter header and tighten by hand until snug. 2. With the engine at ambient temperature and cool to the touch, place a suitable container under the filter. 3. A fuel shutoff valve may be installed on the discharge side of the fuel/water separator.
If installed, turn the handle on the shutoff valve to the closed position (perpendicular to the valve). 9. To eliminate air from the filter, operate the primer pump on the filter header until the fuel purges at the filter assembly. 10. Refer to section Prime the Fuel System and Start the Engine before starting the engine. 4. Drain off some fuel by opening the drain valve. 11. Shut down the engine. Correct any leaks with the engine off. 5. Using a strap wrench, remove the element and bowl together, then remove the bowl from the element. The filter and bowl have right-hand threads, so turn counter-clockwise to remove.
Replace “Fuel Pro® 382/382E” Fuel Filter Element The Fuel Pro 382/383E diesel fuel filter system consists of a permanently mounted fuel processor, a replaceable filter element and sealing grommet assembly, a filter spring, a see-thru cover and seal, a cover collar, and a vent cap and seal. The Fuel Pro 382E system also includes a fuel heater element, thermostatic switch and wiring harness. See Figure 26. 6. Clean the bowl and the O-ring seal. 7. Apply a light coating of clean fuel or grease to the O-ring seal, thread the bowl onto the new filter and tighten by hand . 84 All information subject to change without notice. (Rev.
May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION