Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION OPERATION OPERATION 3 - 88 1. Depress acceleratorpeda l (1) lightly and run the engine w ith no load at midrange speed fo To warm up the hydraulic oil i n cold areas, do as follows. t the 2. 2. After completing the war ming-up operation, check tha engine rotation is smooth, then check that the work equipment control lever is at the HO LD position and set work equipment lock lever (2) to the FREE position. 3. Depress accelerator peda l (1) lightly and run the engine at a mid-range 4. Operate work equipment control lever (3) to TILT positio n (e) and return it to HOLD pos ition (b) to warm up the hydraul ic oil.

The relief time at the tilt po sition (e) should be a maximum of 10 seconds. With this operation, the oil will reach the relief pressure an d this will warm up the hydraulic 5. After carrying out the wa rming-up operation, check that the e normal. , carry out maintenance or repair. gauges and pilot lamps ar If there is any abnormality , carry out maintenance or rep Run the engine under a light load until engine co olant temperature gauge (4) an in the white range. d HST oil temperature gauge (5) are 6. Check for abnormal exha any problem is found, con ust gas color, noise, or vibrati tact your Komatsu distributor. on. If