Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION ADJUSTING WORK EQUIPMENT POSTURE WARNING 3 - 105 Stop the machine on flat ground a wheels. nd put blocks in front and behind the Set parking brake lever to the LOC Secure the front and rear frames K position. with the frame lock bar. he work equipment control lever. Always attach the warning tag to t Do not go under the work equipme nt when the arm is raised. To support the work equipment securely, use the weight of the work equipmen down.

a strong support that can withstand t and prevent the arm coming from The boom kickout makes it pos sible to set the bucket so that it automatically stops at the desire d lifting height (lift arm higher than horizontal) and the bucket positi oner makes it possible to set the bucket so that it automatically st ops at the desired digging angle. The setting can be adjusted to m atch the working conditions. ADJUSTING BOOM KICKOU T ed height, set the work equipment et the work equipment lock lever p the engine.

just plate (2) so that the bottom nter of the sensing surface of hten the bolts to hold the plate in a clearance of 3 to 5 mm (0.118 (2) and the sensing surface of ghten the nuts to hold in position. .6 Nm (1.5 to 2.0 kgm , 10.8 to ine and operate the lift arm control lever. Check that the lever is automatically bucket reaches the desired height. (If equipped) 1. Raise the bucket to the desir control lever at HOLD, then s to the LOCK position and sto 2. Loosen two bolts (1), and ad edge is in line with the ce proximity switch (3). Then tig position. 3. Loosen two nuts (4) to make to 0.197 in) between plate proximity switch (3). Then ti Tightening torque: 14.7 to 19 14.5 lbft) 4.

After adjusting, start the eng returned to HOLD when the 1. Raise the bucket to the desir ed height, set the work equipment et the work equipment lock lever bucket reaches the desired height. 3. Loosen two nuts (4) to make a clearance of 3 to 5 mm (0.118 (2) and the sensing surface of ghten the nuts to hold in position.