Komatsu — ADJUSTING WORK EQUIPMENT POSTURE

. OPERATION OPERATION bucket are the level indicators. 3 - 106 ADJUSTING BUCKET POSITI 1. Lower the bucket to the gro angle, retur n the work equipm ent control lever t o HOLD, t hen set the wor and stop the en 2. Loosen 2 b olts (1), adjust the position of mount ing bracket (4) of the proxi mity switch so that t he rear tip of bar ( 2) is in line with the center o f the sensing surf ace of proximity s witch (3), t hen tighten bolt s to hold the brack et in position. 3. Loosen 2 n uts (5), adjust so th at the clearance b etween bar (2) and the se nsing surface of pr oximity switch (3 ) is 3 to 5 mm (0.118 to 0. 197 in), then tighte n the nuts to hold in position Tightening torque:

14.7 to 19 14.5 lbft) 4. After adjust ing, start the engin e and raise the lift arm. Operate the bucket control lever to the DUMP position, t hen opera te it to the TIL T BACK position and check that the lever is automatical ly returned to the HOLD position wh en the bucket reaches the desired digging a BUCKET LEVEL INDICATOR (A) and (B) at t he top rear of the They check the bucket angle duri (A): Parallel wit h cutting edge