Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE 8.50 2.25 50 WARNING 4 - 21 Amount of water Liters 11.90 10.88 10.03 9.18 US gal 3.14 2.87 2.65 2.42 Ratio % 30 36 41 46 Antifreeze coolant is flamm able, so keep it away from f lame. Antifreeze coolant is toxic. When removing the drain p lug, be carefu l not to get water containing a gets in your eyes, flush yo ur eyes with large amount of fresh water and see a doctor at once.

Use antifreeze and appr opriate water for diluting ( for details, s ee "COOLANT AND WATE 4-5)") We recommend use of an antifreeze density gau ge to contro l the Prepare a container wh ose capacity is larger tha n the specif ied coolant volume to catch Prepare a hose to suppl y antifreeze coolant and 1. Stop the engine. 2. Screw in valve (1) a t the top of the corrosion resistor. (Machines equipped 3. Check that the coo ling water temperature has gone down enough to make it po ssible to touch the radiat or cap surfa ce by hand, then turn rad iator cap (2) slowly until it contacts the e pressure. stopper to release th 4.

Following this, push radiator cap (2), turn it un til it contact s the stopper, then remov e it. 5. Set a container in po sition to catch drained an tifreeze mixture, 6. then open valve (3) After draining the w under the radiator to drai ater, close drain valve (3 n coolant. ) and fill wit h city 7. water. When the radiator is full, start the engine, and run it at low idle. Keep the engine ru nning at low idle for 10 minutes unt il the coolant temperature reaches more than 90°C (194°F). 8. Stop the engine, op then tighten them again. 9. After draining the w ater, clean the cooling sy stem with cl For the cleaning me thod, see the instructions for the cleaning