. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN TRANSFER CASE, ADD OIL WARNING idling, open the cap of oil and wipe off the oil with a the "HOT IDLE" side, 4 - 23 The p arts and oil are at high temperature imm ediately after the engine is stopped, and may cause b urns. Wait for the temperature to go down before s Carr y out this pro cedure if there is any s 1. Start the engi ne and carry out the wa rming-up operation for the transfer. When the w arming-up operation of the ransfer is co mpleted, run the engin REMARK "When the warm ing-up operation of the transfer is completed" means the condition where the transfer oi "Wh temperature has been warmed up to a temperature of approx. 40-60°C.
As a guideli r its own power for 30 - 40 minutes. ne, this condition is usually reached when the machine travels unde As a guideline if t he ambient temperatur e is low (below 0°C), the transfer is warmed up when the machine travels und er its own pow er for approx. 1 hour. 2. iller port (F), cloth. 3. I nsert dipstick (G) fully in the oil filler p 4. The oil level s hould be between the " I f HOT IDLE" s ide of dipstick (G). f the oil level does not reach the (B iller port (F). 5. I f the oil level drain the exce is above the (A) mark ss oil from drain plug ( 6. I t again. f the oil level i hen tighten th