. MAINTENANCE SERVICE PROCEDURE CHECK AXLE OIL LEVEL, ADD OIL WARNING operation. A: Front B: Rear REMARK Remove the mud and dirt from around plug (1), then remove the plug. 2. With cloth, wipe off any oil adhering to the oil level gauge attached to plug (1). 4 - 25 When checking the oil level, a pply the parking brake and secure the front and rear frames with th After stopping the engine, the parts and oil are at a high temperature . W ait for the temperature to go down before starting the Perform this procedure if the re is any sign of oil on the axle case. Inspect the machine on a ho (If the road surface is at an a ngle, the oil level cannot be checked 1. Stop the engine and rem 3.
Set the oil level gauge (G ) as shown in the right diagram . 4. The oil level is correct wh en it is between the two lines provided on the oil level gauge. If the oil level does not rea ch the lower line, add oil through filler port (F). If the oil level is above th e upper line, drain off the excess oil 5. oil through drain plug (P) an d check the oil level again. nstall plug (1). 23 Nm (9.5 to 12.5 kgm , 68.7 to 90.4 6. If the oil level is correct, i Tightening torque: 93 to 1 lbft) Tightening torque: 93 to 1