. MAINTENANCE SERVICE PROCEDURE TURN, REPLACE BOLT-ON CUTTING EDGE WARNING securely to position. 4 - 29 It is dangerous if the w ork equipment moves by m istake during the turning o r replaceme nt operation. Set the work equipme nt in a stable condition, st op the engin the equipmen t lock le the LOCK Turn or replace the cutting edge before the wear reache s the edge o f the b ucke 1. Raise the bucke t to a suitable height, the n put blocks (A) under the bucket to pr event the bucket from co ming down. Raise the bucke horizontal. 2. Remove nuts an d bolts (1), then remove cutting edg 3. Clean the moun ting surface of cutting ed ge (2). 4. Turn cutting edg e (2) and install i t to the bucket.
Wh en turning the edge, install it to the opposite side (l right side, right edge to left If both sides of t he cutting edge are wor n, replace w ith a new part. If the wear ex mounting surfac e before installin g the cu tting edge. 5. Tighten nuts an d bolts (1) uniformly so t hat there is no gap between th e bucket and cu tting edge Tightening torque for mounting bolt: 637 to 853 Nm (65 to 87 kgm , 6. Tighten the mou nting bolts again after o perating for several hour