Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE REPLACE BUCKET TEETH (If equipped) ONE-PIECE TOOTH 4 - 30 When the bucket teet h are worn, replace the m as follows. 1. Raise the bucket t o a suitable height, then put blocks (A) unde the bucket to prev ent the bucket from com ing down Raise the bucket horizontal. the 2. Remove the bolt a nd nuts (1), then remov e bucket t ooth 3. Clean the installat ion surface of bucket to oth (2) 4. Install new teeth t When doing this, clearance between the teeth and the top surface of the bucke Continue to add sh ims until it becomes im possible to add a 0.5 mm (0.02 in) shim If the mounting su before installing th 5.

To prevent any ga p from forming between the teeth and tip of the bucket, ti ghten b olts an d nuts (1) tem porarily, then hit the tip of t he teeth with a hammer Tightening torque for mounting bolt: 863 t o 941 Nm (88 to 96 kgm 637 to 694 lb 6. After operating the machine for a few hou rs, tighten the mounting bolts ag e mounting surface