. MAINTENANCE SERVICE PROCEDURE BUCKET WITH TIP TOOTH WARNING and gloves. is opposite side. 4 - 31 If the pin is h it out with st rong forc e, there is danger t hat the pi n may fl y out. Check th at there is no one in th e surrounding area There is dan ger of piece s flying du ring the r eplacement operation, so alway s wear pr otective clothing, su ch as safety glasses Replace the t eeth before they we ar down as far as the a dapter. 1. 1. Raise the bucket to a suitable height, t hen pu t blocks ( A) und the bucke t to preven t the buc ket from comin g down. Raise the bucket so that the bottom surface of the bucket . surface bucket horizontal 2.
Remove p in (2) installed to th e bucket , then remove t ooth (1 Put a rod (slightly n arrower than the pin) in contact hatched p pin 3. Fit new to oth (1) in ad apter (3 ), push in pin (2) partially by han then knoc k it in with a hamm er. 4. After oper ating the m achine f or a few h ours, check th at the p does not come out. 5. If mountin g bolts (4) of adapt er (3) are loose , tighten them. Tightening torque for mounting bolt: 8 63 to 9 41 Nm ( 88 to 9 6 kgm