. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL FILTER CARTRIDGE WARNING replacing the filter. Do not bring fire or sparks near the fuel. REMARK If the machine has run out of fuel, use Steps 6 to 9 to bleed the air. Container to catch the oil Prepare a filter wrench 1. Open the engine side cover on the right side of the chassis. 2. Set the container to catch the fuel under the filter cartridge. 3. Using a filter wrench, turn filter cartridge (1) counterclockwise on remove it. 4. Clean the filter holder. Fill a new filter cartridge with clean fuel. Coat the packing surface with engine oil. Then install the new cartridge into the filter holder.
Add fuel from small hole (A) (dirty side) at eight places. Do not add fuel from hole (B) (clean side) at the center. NOTICE If the filter cartridge is tightened excessively, the packing will be damaged with sealing surface, turn. 6. Add fuel to the fuel tank gauge). 7. Loosen air bleed plug (2). air bleed plug (2). the filter cartridge, then cartridge. 4 - 48 ture immediately after the machine has been operated. Wait for the engine to cool down before ar the fuel. until full (to FULL mark on the fuel . pump (3), then pump it up and down until no more bubbles co me out with the fuel from hten air bleed plug (2), then push in the knob of priming pump (3) and tighten it. bleed plug:
7.8 to 11.8 Nm (0.8 to 1.2 kgm , 5.8 to 8.7 lbft) hten air bleed plug (2), then push in the knob of priming pum bleed plug: 7.8 to 11.8 Nm (0.8 to 1.2 kgm , 5.8 to 8.7 lbft) rt the engine and check that there is no fuel leakage from the filter seal surface. If there tightening of the filter cartridge. If there is still leakage, follo w Step 2 and 3 to remove check the packing surface for damage or foreign material. If any damage or foreign cking, replace the cartridge with a new part, then repeat Step s 4 to 10 to install the filter