Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACEMENT OF FILTER CARTRIDGE FOR POOR-QUALITY FUEL (If equipped) WARNING replacing the filter. Do not bring fire or sparks near the fuel. Container to catch the oil Prepare a filter wrench 1. Open the engine side cover on the right side of the chassis. 2. Set the container to catch the fuel under the filter cartridge. 3. Using a filter wrench, turn filter cartridge (1) counterclockwise on remove it. 4. Clean the filter holder. Fill a new filter cartridge with clean fuel. Coat the packing surface with engine oil. Then install the new cartridge into the filter holder.

NOTICE If the filter cartridge is tightened excessively, the packing will be damaged and fuel will leak. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. 6. Add fuel to the fuel tank until full (to FULL mark on the fuel gauge). 7. Loosen air bleed plug (2). air bleed plug (2). the filter cartridge. 4 - 49 high temperature immediately after th e machine has been operated. Wait for the engine to cool down before ng, screw in cartridge until seal com es in contact with sealing surface, the n tighten approx. 2/3 turn. nob of feed pump (3), then pump it up and down until no more bubbles co me out with the fuel from g (2).

g the air, tighten air bleed plug (2), then push in the knob of priming pump (3) and tighten it. rque for air bleed plug: 7.8 to 11.8 Nm (0.8 to 1.2 kgm , 5.8 to 8.7 lbft) g the air, tighten air bleed plug (2), then push in the knob of priming pum rque for air bleed plug: 7.8 to 11.8 Nm (0.8 to 1.2 kgm , 5.8 to 8.7 lbft) g the air, start the engine and chec k that there is no fuel leakage from the filter seal surface. If there e, check the tightening of the filter cartridge. If there is still leakage, follo w Step 2 and 3 to remove ridge, then check the packing sur face for damage or foreign material.

I f any damage or foreign und in the packing, replace the cart ridge with a new part, then repeat Step s 4 to 10 to install the filter