. MAINTENANCE SERVICE PROCEDURE CLEAN WATER SEPARATOR STRAINER WARNING 4 - 50 T he engine is at high temperatu re immediately after the machine has been operated. Wait for the engine to cool down before eplacing the filter. D o not bring fire or sparks near 1. Open the engine side cove r on the right side of the chassis. 2. 3. Prepare a container to catc the water separator. Loosen drain valve (1) at th drain the fuel into the conta h the drained fuel and set it under e bottom of the water separator and iner. 4. 5. 6. Loosen ring nut (2), then re Remove strainer (4) from th Wash the interior of straine move cup (3). e separator base. r (4) and cup (3) with clean fuel.
ace it if it is damaged. 7. Check strainer (4) and repl 8. Clean the separator base a nd wash strainer (4), then install the strainer to the separator ba se. f ring nut (2) thinly with grease. 9. Coat the threaded portion o 10. Fill cup (3) with clean fuel, i nstall it to the separator base, then tighten it with ring nut (2). The specified tightening tor que of ring nut (2): m , 27.5 to 31.8 lbft) cause leakage of fuel, so always rque. 37 to 43 Nm (3.8 to 4.4 kg If the ring is loose, it will tighten it to the specified to REMARK Be careful not to lose the O-rin g, float, or spring. Be sure to assemble them after washin 11. After installing filter cup (3), bleed air in the following manner.
12. 13. Loosen air bleed plug (5) o Loosen the knob of feed pu f the fuel filter. mp (6), then pump it up and down until no more bubbles come (5). out with the fuel from air bleed plug 14. After bleeding the air, tighte n air bleed plug (5), then push in the knob of priming pump (6) a nd tighten it. Tightening torque for air ble ed plug: 7.8 to 11.8 Nm (0.8 to 1.2 kgm , 5.8 to 8.7 lbft)