. MAINTENANCE SERVICE PROCEDURE REPLACE HST OIL FILTER ELEMENT WARNING and may cause burns. Wait for the 1. Remove cover (1). NOTICE 4 - 53 The parts and oil are at high te mperature immediately after the engine is stopped tarting the work. temperature to go down before s When removing the oil filler cap, turn it slowly to release the internal pressure, then re 2. Using a filter wrench, turn filt it. 3. Install the new filter cartridg When the packing surface surface of the filter holder, ti Tightening torque: 29 to 39 lbft) When the packing surface surface of the filter holder, ti 4. Run the engine at low idle for HST circuit. 5.
Check that the hydraulic oil i see "CHECK OIL LEVEL I (PAGE 4-40)". 6. Run the engine at low idle, and extend and retract the steering, bucket, an d lift arm cylinders 4 to 5 times. Be careful not to operate the cyl inder to the end of its stroke (stop approx. 100 m m (3.9 in) before the e nd of stroke). If the engine is run at high speed im mediately after startup or a cylinde r is pushed up to its stroke end, air taken insi de the cylinder may cause damage to the piston pa 7. Operate the steering, bucke t, and lift arm cylinders to the end of their strok e 3 to 4 times, then st op the engine and loosen filler cap to blee d the air from the hydraulic tank. is at the specified level.
For details, see "CHECK OIL LEVEL IN HYDRAULIC 0)". d operation, install cover (1). 8. Check that the hydraulic oil TANK, ADD OIL (PAGE 4-4 9. After completing the air blee Replace the HST filter element if the HST oil filter clogging warning pilot lamp lig hts up, even if 1000 h ours or 1 year has not passed.