Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE (1) Center hinge pin (2 places) 4 - 54 REPLACE CORROSION RESISTOR CARTRID GE e chassis. 1. 2. 3. 4. 5. 6. 1. Open the engine side cover o n the left sid e of th 2. Set 2 l evers (1) a t the top of the corrosion resist or to the sid to the CLOSED p osition. 3. Using a filter wre nch, turn car tridge (2) to t he left to remove i 4. Apply engine oil t o the sealing surface of a new c artridge, the install it to the filte r holder. 5. Bring t he packing surface int o contact with the se al surface the filt er holder, t hen tighten i t further approx. 2/3 turn 6. Set 2 l evers (1) v ertically to t he OPEN position. LUBRICATING 1.

Using a grease p ump, pump in grease through t he grease fi ttings marked by the arrows 2. After g reasing, wi pe off any o ld grease tha t was pushed out. (2) Engine stop solen oid linkage (1 place) CHECK TIGHTENING PARTS OF TURBOCHARGER Contact yo ur Komats u distributor to have t he t ighten ing portions CHECK PLAY OF TURBOCHARGER ROTOR Contact yo ur Komats u distributor to have t he r otor pl ay checked