John Deere 450CLC Excavator — Grease Swing Bearing

Maintenance—Every 500 Hours Replace Hydraulic Tank Oil Filter 1. Park machine on a level surface with arm cylinder fully retracted and bucket cylinder fully extended. 2. Stop engine. CAUTION: High pressure release of oil from pressurized system can cause serious burns or penetrating injury. The hydraulic tank is pressurized. DO NOT remove hydraulic cap. Relieve pressure by SLOWLY loosening cap. T6811AI —UN—18OCT88 3. SLOWLY loosen cap (1) to relieve pressure. 4. Hold down filter cover (2) against light spring load when removing the last two cap screws. 1— Hydraulic Cap 2— Hydraulic Oil Filter Cover T134997 —UN—01NOV01 TX14740,0001CFA -19-29JUN06-1/2 5.

Remove spring (3), valve (4), and filter element (5). 6. Discard filter element and O-ring (2). NOTE: Remove element and inspect for metal particles and debris in bottom of filter canister. Excessive amounts of brass and steel particles can indicate a hydraulic pump, motor, or valve malfunction, or a malfunction in process. A rubber type of material can indicate cylinder packing problem. 7. Install filter element, valve, and spring. 8. Install cover (1) and tighten cap screws. Specification Cap Screw—Torque....................................................... 50 N·m (37 lb-ft) T140263 —UN—21MAR01 9. Tighten cap. 10. Bleed air from hydraulic system.

(See procedure in this section.) 1— Cover 2— O-Ring 3— Spring 4— Valve 5— Filter Element TX14740,0001CFA -19-29JUN06-2/2 3-8-5 060313 PN=100