John Deere 450CLC Excavator — Unified Inch Bolt and Screw Torque Values

Miscellaneous—Machine Check Track Shoe Hardware Tracks shoes should be checked periodically for loose or missing cap screws and nuts. For shoes with missing or loose cap screws and nuts, remove shoes and clean the mating surface of shoes and links before tightening cap screws and nuts. The cap screws should be replaced because they have been stretched to yield previously. T6352AH —UN—23FEB89 Operating a machine with loose shoes can cause the cap screws and holes in the shoes and links to wear making it difficult to keep the shoes tight. Loose shoes can also cause hardware failure and loss of shoes. 1. Clean the mating surface of shoe and links. Install shoes. Cap Screw Tightening Sequence 2.

Apply a light coating of oil to cap screw threads before installing. 4. Starting at any cap screw, tighten all cap screws in sequence shown to specification. 3. Install nuts with the rounded corners against milled surface of link and chamfered side is away from link. Check that nuts are square with the milled surface of link and there is full contact between nut and milled surface. As necessary, hold the nut so it does not turn. TX14740,0001CFC -19-03JAN12-1/1 4-1-17 060313 PN=130