John Deere 450CLC Excavator — Check Track Shoe Hardware

Miscellaneous—Machine 2. Measure distance (D) between the bushing (B) and the arm. This distance should not be adjusted below 0.5 mm (0.020 in.). 3. Remove plate (F). A—Bucket B—Bushing C—Pin D—Clearance E—Shim F—Plate T6879DU —UN—06DEC88 04T,90,M210 -19-29JUN06-2/3 NOTE: Alternate buckets may have different adjustment procedures. 4. Remove shim(s) according to distance measured. This will allow the bushing to move to the right and take up the excessive play. T95788 —UN—10NOV88 5. Install plate and tighten cap screws. 6. Slide O-ring back into position. 04T,90,M210 -19-29JUN06-3/3 Removing the Bucket 3. Slide O-ring seals out of way. Remove bucket pins. 1. Lower bucket to the ground. 2.

Remove snap rings and locking pins. 4. Install and adjust bucket. See Adjust Bucket To Arm Joint in this section. 04T,90,M35 -19-29JUN06-1/1 Track Sag General Information To maximize undercarriage life, keep track sag within specification. Tracks may require adjustment several times during a working day due to changing soil type and moisture content. will result in excessive pin and bushing wear, sprocket popping, tooth tip wear, and excessive loads on the entire undercarriage and travel drive system. Machine productivity and fuel consumption are also adversely affected because increased horsepower is needed to move the machine. Adjust tracks in the actual operating conditions. TIGHT TRACK:

Packing causes a tight track. If material packs in the undercarriage, adjust tracks with the material packed in the components. LOOSE TRACK: A loose track has more side to side motion, increasing side wear on the links, rollers and front idler. An excessively loose track will slap at high ground speeds, resulting in high impact loads on the sprocket teeth, bushings, and carrier rollers. While the track spring will recoil and the machine can continue to operate with a tight track, continued operation 04T,90,M197 -19-11MAY06-1/1 4-1-16 060313 PN=129