Miscellaneous—Operational Checkout Travel System Tracking Checks (Travel Only) Engine at fast idle. Travel speed switch in fast position. 6 8 7 5 6 TX1120481 —UN—17AUG12 Tracking Check 5— Distance of Mistrack 6— Acceleration and Deceleration Zone (approximately): 3—5 m (10—16 ft.) 7— Test Line (distance): 20 m (66 ft.) 8— Track Print Operate machine at full travel forward speed on a flat and level surface approximately 30 m (99 ft.). NOTE: When machine mistracks right, hydraulic pump 1 circuit oil flow may be less than specification. When machine mistracks left, hydraulic pump 2 circuit oil flow may be less than specification. Observe direction of mistrack.
Create a straight test line 20 m (66 ft.) (7) long between two points on track print (8). Measure and record greatest distance of mistrack (5) between inside edge of track print and test line. Repeat procedure in reverse travel. YES: Go to next check. LOOK: Do both tracks move and machine does not mistrack excessively in forward or reverse? NO: Note which track does not move, or if machine mistracks note the mistrack pattern. Go to your authorized dealer. VD76477,0000057 -19-12SEP12-17/27 Travel System Tracking Checks (While Operating A Digging Function) Engine at fast idle. Travel speed switch in fast position. Travel machine at full speed forward on a flat and level area.
After machine is moving, slowly move the arm control lever from neutral to full actuation to extend the arm. Does machine mistrack excessively when the arm is extended? YES: Go to your authorized dealer. NOTE: Machine will slow down during this test. NO: Go to next check. Continued on next page VD76477,0000057 -19-12SEP12-18/27 4-3-9 060313 PN=151