John Deere 450CLC Excavator — Starting Engine

Operation—Operating the Machine Starting the Engine 1. Move engine rpm dial (1) to slow idle position. min-1 2. Sound horn to alert persons nearby. IMPORTANT: Prevent starter damage. Never operate starter for more than 20 seconds at a time. If engine fails to start, return key switch to OFF. Wait for about 2 minutes, then try again. After a false start, DO NOT turn key switch until engine stops. Slow Idle T136300 —UN—24JAN01 3. Turn key switch to START. All indicator lights will stay on for approximately 3 seconds. Release key; switch will return to ON position. 1 1— Engine RPM Dial After Starting Check IMPORTANT: Prevent possible damage to engine.

If indicator lights do not go out after starting engine, IMMEDIATELY STOP THE ENGINE. Find and correct the problem. Warming the Engine 1. Run engine at 1/3 speed for 30 seconds. Do not run engine at fast or slow idle. Do not accelerate rapidly during warm-up. After the engine is started, the indicator lights should go out except for the dig mode indicator which will remain on. If they do not, stop the engine immediately. Find and correct the problem. 2. Operate machine at less-than-normal loads and speeds until engine is at normal operating temperature. DW90712,000016C -19-29JUN06-2/2 2-2-2 060313 PN=42