John Deere 450CLC Excavator — Weights

Operation—Operating the Machine Lower Boom With Engine Stopped 2 3 When an engine stops during operation, an accumulator in the pilot circuit provides pilot pressure to lower the boom. Use the following procedure to lower the boom only if the accumulator is discharged. 1 1. Slowly turn the boom up circuit relief valve assembly (3) out a maximum of one turn to lower the boom to the ground. Boom up circuit relief valve is at the bottom of the control valve in the 4-spool side. NOTE: Turning the circuit relief valve assembly out opens a path for oil to flow from the head end of boom cylinders to the control valve return passage. T140013 —UN—16APR01 2.

Tighten the circuit relief valve after boom is on the ground. 1— 5-Spool Control Valve 2— 4-Spool Control Valve 3— Boom Up Circuit Relief Valve Assembly T140013 Boom Up Circuit Relief Valve DW90712,0000175 -19-29JUN06-1/1 Parking the Machine IMPORTANT: During freezing weather, prevent damage to undercarriage components from frozen mud and dirt. Machine must be parked on a solid level surface to prevent tracks freezing in the ground. 4. Run engine with engine rpm dial at 1/3 position without load for 2 minutes. 5. Turn engine rpm dial to slow idle position. 6. Turn key switch to OFF. Remove key from switch. 7. Pull pilot shut-off lever to locked position. 1.

Park machine on a solid level surface. During freezing weather, clean mud and dirt from tracks, rollers and track frames. IMPORTANT: Prevent cab electrical component damage from bad weather. Windows, roof vent, and cab door must be closed to prevent enter of rain. If tracks are frozen in the ground, slowly raise the machine using boom to free the tracks. Move machine carefully. 8. Close windows, roof vent, and cab door. 2. Lower equipment to the ground. 3. Turn auto-idle/auto-acceleration switch OFF. 9. Lock all access doors and compartments. IMPORTANT: Turbocharger can be damaged if procedure to shut down engine is not done properly.

DW90712,0000176 -19-29JUN06-1/1 Prepare Machine for Loading On a Trailer Before your machine can be loaded on a trailer for transporting, it must be broken down to the correct size and weight. 2. Change track gauge from work to transport width. (See Section 2-2.) All local and state size and weight regulations must be met. 3. Remove bucket. (See Section 4-1.) 1. Remove counterweight. DW90712,0000177 -19-29JUN06-1/1 2-2-9 060313 PN=49