Operation—Operating the Machine Operating In Water and Mud Be careful not to operate the machine in water or mud above the upper deck surface of the undercarriage, causing the swing bearing and rotary manifold to be submerged. If the swing bearing and rotary manifold are submerged, remove cover from underneath center of machine. Remove drain plug (1) to drain water and mud. T136459 —UN—18DEC00 Clean swing gear area. Install plug and cover. Grease swing gear and swing bearing. (See Section 3-7.) 1— Drain Plug DW90712,0000172 -19-29JUN06-1/1 Driving Up a Steep or Slippery Slope CAUTION: Prevent possible injury from machine rollover. Use this technique only on a short slope.
Machine depends on support of boom/arm/bucket during entire procedure until machine reaches top of slope. Repositioning the bucket during this procedure is NOT recommended. DO NOT swing upperstructure during this procedure. DO NOT reposition bucket during this procedure. 2. Position undercarriage so travel motors will be on uphill end of machine. 3. Push bucket into the ground. 4. When boom is on uphill end of machine: Pull machine using boom and arm cylinder to help travel motors. When boom is on downhill end of machine: Push machine using boom and arm cylinder to help travel motors. 1. Wear seat belt. DW90712,0000173 -19-29JUN06-1/1 Lifting CAUTION: Lifting requires special care.
Observe these rules when lifting with your machine: Never use machine to lift people Do not exceed lift capacity limits Keep everyone clear of raised loads Never attach sling or chain to bucket teeth Use tether lines to guide loads Use hand signals to communicate with others T133649 —UN—02NOV00 Without Bucket Loop 1. Use proper rigging to attach and stabilize loads. 2. Without bucket loop: Curl bucket and retract arm. Fasten sling or chain to bucket pivot pin. T135070 —UN—02NOV00 With bucket loop: Curl bucket and retract arm. Fasten sling or chain to bucket loop. 3. Check stability by carefully doing a trial lift:
Raise load just off of ground Swing load all the way to one side Move load slowly away from machine Lower load immediately if machine is not stable With Bucket Loop DW90712,0000174 -19-29JUN06-1/1 2-2-8 060313 PN=48