John Deere 450CLC Excavator — Counterweight Removal (With Hydraulic Removal Option)

Operation—Operating the Machine 6. Remove bottom covers (C and E). 7. Lift counterweight enough so weight of the counterweight is supported by the lifting device (D). C—Bottom Cover D—Lifting Device E—Bottom Cover T8175AK —UN—20FEB94 View looking up from below machine DW90712,0000179 -19-29JUN06-3/10 8. Set variable orifice (A) by turning in the direction of the arrow until closed. Then open orifice two turns. Adjust as required to achieve desired counterweight lowering speed. Every 1/8 turn of the variable orifice changes the lowering cycle time approximately 6 seconds. IMPORTANT:

Linkage pivot areas may bind if not properly lubricated resulting in failure of the counterweight lift cylinder to raise counterweight to full height. T8172AF —UN—20FEB94 9. Grease all pivot areas of counterweight lift linkage (three fittings at the bottom and one fitting at the top of the counterweight cylinder) the FIRST TIME and every third time the counterweight device is operated. A—Variable Orifice DW90712,0000179 -19-29JUN06-4/10 10. Turn the handle of shut-off valve (A) (located through opening under the engine) counterclockwise to open hydraulic pressure to counterweight lift cylinder (B).

A—Shut-off Valve B—Lift Cylinder T8172AP —UN—20FEB94 Continued on next page DW90712,0000179 -19-29JUN06-5/10 2-2-11 060313 PN=51