John Deere 450CLC Excavator — Counterweight Removal (With Hydraulic Removal Option)

Operation—Operating the Machine 11. Loosen adjusting cap screws (A) and jam nuts to loosen lifting yokes (D) from counterweight pin brackets. 12. Slide the lifting yokes forward to the upward position of slot (C) away from the rear of counterweight (E). 13. Tighten adjusting cap screws enough to hold both lifting yokes in the forward position. Tighten jam nuts. A—Adjusting Nut (2 used) B—Yoke-To-Counterweight Pin (2 used) C—Slot D—Yoke (2 used) E—Counterweight T8172AU —UN—20FEB94 DW90712,0000179 -19-29JUN06-6/10 14. Open left rear access door and pull off lever cover (A) of counterweight pilot control valve (B). 15. Start the engine. Run machine in “precision” work mode at slow idle. 16.

Leave pilot shut-off lever in locked (UP) position. T107391 —UN—06MAR97 CAUTION: To ensure good footing and visibility always stand on the machine service walk when operating counterweight pilot control valve. 17. Slowly move the counterweight pilot control valve lever UP and DOWN several times to check the response of cylinder control. A—Cover B—Control Valve Continued on next page DW90712,0000179 -19-29JUN06-7/10 2-2-12 060313 PN=52