John Deere 450CLC Excavator — Counterweight Installation With Hydraulic Removal Option

Operation—Operating the Machine 5. Open shut-off valve (1). 6. Start the engine. 7. Turn engine RPM dial to slow idle. 8. Push precision mode switch to ON. 9. Leave pilot shut-off lever in locked (UP) position. CAUTION: To ensure good footing and visibility always stand on the machine service walk when operating counterweight pilot control valve. T139708B —UN—07MAR01 10. Lower counterweight cylinder. 1— Shut-off Valve Shut-off Valve DW90712,000017B -19-29JUN06-2/6 11. Install counterweight lifting yoke link pins (E) to the counterweight pin brackets. Slide yoke (D) forward to the top position of the slot in the counterweight pin bracket. IMPORTANT:

To ensure full thread engagement of cap screw (B) in the yoke (D), length (A) must not exceed 120 mm (4-3/4 in.) NOTE: In order to achieve proper alignment of cap screws and counterweight bosses to machine mainframe, the length (A) of each adjusting cap screw (B) may vary from side to side of the counterweight. 12. Adjust cap screw (B) on each yoke (D) to length (A). Tighten nut (C). Counterweight—Specification Head Of Cap Screw To Yoke—Length.........................................115 mm (4-1/2 in.) approximate 13. Slowly raise counterweight to full height. 14. Check counterweight boss and cap screw alignment. T8174AL —UN—23SEP94 15. As necessary, lower counterweight and adjust length (A).

To raise counterweight, decrease length. To lower counterweight, increase length. A—115 mm (4-1/2 in.) Approximate B—Adjusting Cap Screw (2 used) C—Nut (2 used) D—Yoke (2 used) E—Yoke-To-Counterweight Pin (2 used) F—Washer (2 used) G—Lock Pin (2 used) H—Flat Washer (2 used) Continued on next page DW90712,000017B -19-29JUN06-3/6 2-2-17 060313 PN=57