John Deere 450CLC Excavator — Belt Tensioner Spring Check

Maintenance—As Required Clean Radiator Air Inlet Screen Remove wing nuts and slide screen (1) up for cleaning. 1— Inlet Screen T140228 —UN—21MAR01 TX14740,0001CF3 -19-20MAR01-1/1 Belt Tensioner Spring Check Belt drive systems equipped with automatic (spring) belt tensioners cannot be adjusted or repaired. The automatic belt tensioner is designed to maintain proper belt tension over the life of the belt. 1 A belt tension gauge will not give an accurate measure of the belt tension when automatic spring tensioner is used. 1. Start engine and run at fast idle. Engine must not emit a loud squealing sound at slow idle, high rpm, or rapid acceleration.

If belt drive produces a squealing under any of these conditions, shut off engine and proceed to step 4. If belt drive does not produce a squeal, proceed to next step. 2 2. Turn on air conditioner and headlights (high beam). If belt drive produces a squealing under any of these conditions, shut off engine and proceed to step 4. If belt drive does not produce a squeal, belt drive is OK. 3. Check belt regularly for wear. Replace if necessary. 4. If the belt does not show any signs of excessive wear, and the belt drive squealed loudly during the performance of steps 2 and 3, replace belt tensioner. T142947 —UN—08JUN01 5.

Using a breaker bar, slowly release tension from belt by rotating belt tensioner away from belt. Continue rotating belt tensioner until belt tensioner stop is contacted. Slowly return belt tensioner back to belt tensioned position. If the tensioner exhibited excessive “roughness” or hesitancy during rotation, replace belt tensioner. 1— Belt Tensioner 2— Belt Tensioner TX14740,0001D20 -19-07JUN01-1/1 3-3-2 060313 PN=80