John Deere 450CLC Excavator — Bleed Fuel System

Maintenance—As Required Inspect Serpentine Belts 1. Check belts (1 and 2) regularly for wear, especially for cracks at the bottom of grooves and for frayed edges. IMPORTANT: If either belt is stretched to the point that the belt tensioner is against its stop, belt must be replaced. T141920B —UN—03MAY01 2. If necessary, replace belt. 3. Remove lower fan guard. NOTE: Alternator belt requires a 1/2 inch square drive tool and fan belt requires a 3/4 inch square drive tool to release belt tension. 4. Hold tension adjuster assembly away from belt while removing old belt and installing new belt. 1— Belt 2— Belt 5. Install fan guard.

OUOE003,00000B1 -19-14MAR01-1/1 Drain Primary Fuel Filter (Water Separator) 1. Open front engine door to access water separator. 2. Open drain valve (1) and pump primer (2) to extract water or debris from fuel system. Collect waste in a container and dispose of it properly. T141910B —UN—02MAY01 3. Close drain valve. 4. Bleed fuel system. (See Bleed Fuel System in this Section.) 1— Drain Valve 2— Primer TX14740,0001D15 -19-20APR01-1/1 3-3-3 060313 PN=81