Maintenance—Every 10 Hours or Daily Check Recovery Tank Coolant Level IMPORTANT: Avoid mixing different brands or types of coolant. Coolant manufacturers engineer their coolants to meet certain specifications and performance requirements. Mixing different coolant types can degrade coolant and machine performance. T140548B —UN—26MAR01 With the engine cold, coolant level must be at the FULL mark on the recovery tank (1). If coolant is below the FULL mark, add coolant to the recovery tank. CAUTION: Prevent possible injury from hot spraying water. DO NOT remove radiator filler cap unless engine is cool. Then turn cap slowly to the stop. Release all pressure before you remove cap.
If recovery tank is empty, check for leaks. Repair as required. Add coolant to the radiator and the recovery tank. T6274AQ —UN—18OCT88 NOTE: If recovery tank is full and radiator is low, check for leaks in radiator cap and hose connections between radiator and coolant recovery tank. Coolant level must be at bottom of the filler neck. 1— Recovery Tank VD76477,0000107 -19-22JUL05-1/1 Check Engine Oil Level IMPORTANT: Prevent engine damage. Do not run engine when oil level is below the ADD mark. The most accurate oil level reading is obtained when the engine is cold before starting the engine for the day's operation. T141907B —UN—02MAY01 1. Make sure dipstick (1) is fully seated. 2.
Remove dipstick to check oil level. BEFORE THE ENGINE IS STARTED: The engine is full when oil level is in the cross-hatch area (3). It is acceptable to run the engine when the oil level is above the ADD mark. AFTER THE ENGINE HAS BEEN RUN: Allow the oil to drain into the oil pan for 10 minutes before checking the oil level. Ten minutes after shutdown the engine oil level must be above the ADD mark. T144208 —UN—27JUL01 3. If necessary, remove filler cap (2) to add oil. (See Section 3-1.) 1— Dipstick 2— Filler Cap 3— Cross-Hatch Area TX14740,0001D02 -19-27MAR01-1/1 3-4-1 060313 PN=85