John Deere 450CLC Excavator — Change Engine Break-In Oil and Replace Filter

Maintenance—Initial Service - 250 Hours Change Engine Break-In Oil and Replace Filter NOTE: Break-in oil should be changed after the first 250 hours of operation. See Engine Break-In Oil in section 3-1. T140551B —UN—26MAR01 1. Run engine to warm oil. 2. Park machine on a level surface. 3. Stop engine. 4. Remove drain plug (1) from bottom of engine oil pan, or open drain valve on side of engine oil pan. Allow oil to drain into a container. Dispose of waste oil properly. 5. Turn filter (2) counterclockwise to remove. Clean mounting surface on base. 6. Apply thin film of oil to rubber gasket of new filter. 7. Install new filter.

Turn filter clockwise by hand until gasket touches mounting surface. T141909B —UN—02MAY01 8. Tighten filter 1/2—3/4 turn more. 9. Install drain plug or close drain valve. 10. Remove fill cap. Specification Engine—Oil Capacity With Filter Change.......................................................... 42.0 L (11.1 gal) 1— Drain Plug 2— Filter 11. Fill engine with oil. (See Section 3-1.) 14. Stop engine. Check oil level. Check for any leakage at filter. Tighten filter just enough to stop leakage. 12. Install fill cap. 13. Start engine. Engine oil pressure indicator must go out within 15-20 seconds. If not, stop engine immediately and find the cause.

TX14740,000013D -19-11JUL06-1/1 3-6-1 060313 PN=89