Maintenance—Every 250 Hours Clean or Replace Dusty Primary Element 1. Tap element (1) with the palm of your hand, NOT ON A HARD SURFACE. CAUTION: Prevent possible injury from flying chips if compressed air is more than 210 kPa (2.1 bar) (30 psi). Reduce compressed air to less than 210 kPa (2.1 bar) (30 psi) when using for cleaning purposes. Clear area of bystanders, guard against flying chips, and wear personal protection equipment including eye protection. T136457 —UN—18DEC00 2. If this does not remove dust, use compressed air under 210 kPa (2.1 bar) (30 psi). 3. Direct air up and down the pleats from inside to outside. Be careful not to make a break in the element.
1— Air Cleaner Element IMPORTANT: A damaged or dirty element may cause engine damage. 3. After 1000 hours service or annually. DO NOT clean a secondary element. Install a new element carefully centering it in the canister. Install a new primary (outside) element: 1. If the element shows damage. 2. If element will not clean. 3. After 1000 hours service or annually. 1. Inspect element and gasket for damage. 2. Air restriction indicator will not signal correctly if an element has a break or is not correctly sealed in air cleaner housing. Throw away element that has the slightest damage. If gasket is broken or missing, install a new element. Install a new secondary (inside) element: 1.
If the primary element is damaged and needs to be replaced. 2. If the element is visibly dirty. TX14740,0001CAD -19-29JUN06-1/1 3-7-2 060313 PN=91