Maintenance—Every 500 Hours Grease Swing Bearing Gear CAUTION: Prevent possible injury from unexpected machine movement if controls are moved by another person. Lubricating swing bearing gear and rotating the upperstructure must be done by one person. T140499 —UN—27MAR01 1. Remove swing bearing gear access cover (1). 2. Grease must be to bottom of the swing bearing gear teeth. The grease must also be free of contamination by dirt and water. If the grease is contaminated, remove grease and replace with clean grease. Located In Tool Box IMPORTANT: If water or mud is found in swing gear area, See Operating in Water and Mud. (See Section 2-2.) 1— Access Cover 4.
Remove any excess grease from over the top of the swing drive pinion. 3. Add grease as required. (When completely dry or after running in mud or water swing bearing gear capacity is approximately 15.4 kg (34 lb). (See Section 3-1.) 5. Install access cover. IMPORTANT: Excessive grease can damage the swing gearbox seal. TX14740,0001CF8 -19-20MAR01-1/1 Check Air Intake Hose Check air intake hoses for cracks. Replace as necessary. TX14740,0001C82 -19-04NOV00-1/1 3-8-1 060313 PN=96