John Deere 450CLC Excavator — Replace Primary Fuel Filter (Water Separator)

Maintenance—Every 500 Hours Change Engine Oil and Replace Filter NOTE: Break-in oil should be changed after the first 100 hours of operation. See Engine Break-In Oil in section 3-1. 1. Run engine to warm oil. T140551B —UN—26MAR01 2. Park machine on a level surface. 3. Stop engine. 4. Remove drain plug (1) from bottom of engine oil pan, or open drain valve on side of engine oil pan. Allow oil to drain into a container. Dispose of waste oil properly. 5. Turn filter (2) counterclockwise to remove. Clean mounting surface on base. 6. Apply thin film of oil to rubber gasket of new filter. 7. Install new filter. Turn filter clockwise by hand until gasket touches mounting surface.

T141909B —UN—02MAY01 8. Tighten filter 1/2—3/4 turn more. 9. Install drain plug or close drain valve. 10. Remove fill cap. Specification Engine—Oil Capacity With Filter Change.......................................................... 42.0 L (11.1 gal) 11. Fill engine with oil. (See Section 3-1.) 1— Drain Plug 2— Filter 12. Install fill cap. 14. Stop engine. Check oil level. Check for any leakage at filter. Tighten filter just enough to stop leakage. 13. Start engine. Engine oil pressure indicator must go out within 15-20 seconds. If not, stop engine immediately and find the cause. TX14740,0001CE1 -19-29JUN06-1/1 Replace Primary Fuel Filter (Water Separator) CAUTION:

If engine has been running, engine and fuel filter housing may be hot. 1. Clean entire top area of fuel filter assembly to keep debris from entering fuel system. T141910C —UN—03JUL01 1— Cap Continued on next page TX14740,0001D3A -19-03JUL01-1/4 3-8-2 060313 PN=97