John Deere 450CLC Excavator — Replace Primary Fuel Filter (Water Separator)

Maintenance—Every 500 Hours 2. Remove cap (1) from fuel filter housing. NOTE: Relieve vacuum in filter housing by operating hand primer until fuel filter “pops up”. If filter does not “pop after about 30 strokes of primer, insert a small screwdriver as shown to carefully pry under filter flange to relieve vacuum in the housing. RG10303 —UN—27MAY04 TX14740,0001D3A -19-03JUL01-2/4 3. Remove filter element as shown. Hold filter suspended straight up in top of housing to drain fuel from filter. 4. Dispose of used filter properly. 5. Drain fuel from water separator bowl. (See Section 3-3.) NOTE: If sediment in bowl cannot be flushed out by pumping primer, remove bowl to clean. 6.

Clean sediment from water separator bowl. (See Section 4–1.) RG10304 —UN—02SEP99 TX14740,0001D3A -19-03JUL01-3/4 IMPORTANT: Fuel level below the MIN indication may result in trapped air in the filter causing the engine to stall and not restart without additional system purging. Fuel level above the MAX indication may cause fuel to overflow from the filter housing during insertion of filter element. RG10305 —UN—02SEP99 7. Pump primer until fuel reaches the MAX (A) level. 8. Insert new (dry) fuel filter into filter housing. 9. Install fuel filter cap and hand tighten. 10. Pump primer 20 strokes. 11. Start engine. Run engine at slow idle for 5 minutes.

A—Maximum Level 63 mm (2-1/2 in.) From Top of Housing (New Filter) B—Minimum Level 127 mm (5 in.) From Top of Housing TX14740,0001D3A -19-03JUL01-4/4 3-8-3 060313 PN=98