Komatsu — 5.7.5. PARKING BRAKE

MAINTENANCE SECTION 5 Page 21 BRAKES 5.7.4. FILLING AND VENTING THE SYSTEM 1. Reassemble all lines (if disconnected). Do not assemble the brake system warning light switch. 2. Fill the master cylinder with brake fluid. 3. “Pump” the brake pedal and add more fluid until the fluid level is 6 [mm] below the top edge of the master cylinder. 4. If the system is aerated (“soft“ pedal), vent the system in the following way: a). loosen the axle bleeder screws, connect a transparent plastic tube on the valve. Put the other end of the tube in a small amount of oil in a clear container (Fig. 6.9). b).

depress the brake pedal (air bubbles should escape through the plastic tube dipped in the brake fluid), c). when clear fluid without air bubbles starts flowing out, turn on the bleeder screws and release the pedal, d). repeat the above steps for each of the four bleeder screws, e). assemble the brake system warning light switch. 5.7.5. PARKING BRAKE The parking brake is mounted on the front differential housing. It is a two shoe internal expanding type, actuated by a hand lever in the operator’s compartment. When the parking brake is applied the electrical switch activates the indicator light and buzzer. CHECKING THE OPERATION WARNING!

Before entering the operator’s compartment, walk completely around the machine and clear the area of personnel and obstructions. WARNING! When testing the parking brake, be sure the area near the machine is clear of personnel and obstructions because the machine may move during this test. 1. Start and operate the engine at low idle to warm up the engine. Refer to “STARTING THE ENGINE”, Section 4. 2. With the parking brake engaged, place the transmission gear range lever in the third gear, and the transmission direction lever in “FORWARD”. Slowly depress the accelerator pedal until it is fully applied. IMPORTANT: DO NOT test the brake for more than 1o seconds. 3.

If the parking brake holds the machine stationary in this third speed stall condition, the brake system is satisfactory. 4. If the parking brake dose not hold the machine stationary in this speed stall condition, release the accelerator pedal, apply the service brakes, place the transmission direction lever in “NEUTRAL”, lower the bucket to the ground, and stop the engine. WARNING! If the parking brake does not hold the machine stationary correct the cause. Until the cause is corrected, park the machine on level ground and block the tires to prevent it from moving. DRESSTA OM515C520C99/1E