SECTION 5 MAINTENANCE Page 22 BRAKES 5. Inspect the parking brake. If service is necessary, consult your distributor (the minimal brake shoes thickness is 4 [mm]). 6. After the deficiencies have been corrected, recheck the system by repeating steps 1 thru 3. WARNING! After operating a machine in poor conditions (mire, clay), to avoid penetration of dirt into the parking brake, which can cause deterioration of braking capability), wash the brake with water and dry it with compressed air. If the brake has been soiled, clean all metal parts, coat the latches with Litomos EP-23 grease (or equivalent, refer to chart 2, section 5.4). 5.8.
COOLING SYSTEM GENERAL The cooling system operates under pressure which is controlled by the pressure relief valve in the radiator cap. The belt driven water pump circulates the coolant through the engine block, cylinder heads, radiator, and engine oil cooler. In the radiator bottom tank there is an oil cooler which cools the transmission oil (Fig. 6.3). Machines in EC configuration are equipped with another “oil-air” type transmission oil cooler connected serially with the standard oil cooler. This additional cooler is mounted on the standard cooler housing at the rear of the machine coolant.
Circulation is controlled by the thermostat which by-passes coolant flow around the radiator until the engine reaches operating temperature. Proper cooling is possible only when the system is sealed, the radiator cap gasket is in good condition, the pressure relief valve and thermostats are operating properly, the system is free of coolant and air flow restrictions and is filled to the proper level. Selection and maintenance of the engine coolant is important to long engine life. The following information provides recommendations for selecting the engine coolant, maintaining the coolant inhibitors and servicing the cooling system.
The system operates successfully with a water/antifreeze mixture of inhibited/conditioned water as the coolant. Water alone allows rust, scale deposits, and corrosion to occur within the system. 5.8.1. WATER Use water which has a low mineral content. Water used in conjunction with antifreeze, coolant filters and inhibited water must meet the following standards: Total hardness: Not to exceed 170 parts per million to prevent scale deposits. Water containing dissolved magnesium and calcium (the usual reason for water hardness) above the specified amount will cause scale deposits to develop in the engine. Chlorides - Not to exceed 100 parts per million to prevent corrosion.
Dissolved solids - Not to exceed 340 parts per million to minimize sludge deposits, scale deposits and corrosion. If any of the requirements cannot be met, use distilled, de-ionized or de-mineralized water. To determine if the local water supplies meet these standards, water samples can be tested by water treatment laboratories. Softened water that is prepared using common salt (sodium chloride) contains excessive amounts of chlorides and should not be used. OM515C520C99/1E DRESSTA