SECTION 5 MAINTENANCE Page 26 COOLING SYSTEM Fig. 5.11. Radiator Drain Plug Fig. 5.12. Cab Heater Water Valve 5.8.6. CLEANING THE SYSTEM NOTE: If necessary, clean the cooling system in accordance with the instructions of Engine Operation and Maintenance Manual and the cleaning compound’s manufacturer. 5.8.7. FILLING THE SYSTEM NOTE: Be sure to fill the heater and heater supply lines with fresh coolant, even if the heater is not in use (warm weather). Leaving the heater core empty causes corrosion in the heater. 1. Be sure the radiator drain valve and engine drain plugs are closed. 2. Fill the cooling system to the required capacity. For filling use antifreeze specified in Chart 2.
It is recommended to use antifreeze according to the ambient temperature. 3. Start the engine and run it idle until the normal operating temperature is reached. Add coolant as needed to keep the level to the neck of the radiator visible in the sight gauge. 4. After all air is removed and level remains fixed, install the radiator cap and check the system for leaks. OM515C520C99/1E DRESSTA