Komatsu — 5.9.1. CHECKING THE OIL LEVEL

MAINTENANCE SECTION 5 Page 27 COOLING SYSTEM IMPORTANT! Never add coolant into the radiator of an overheated engine unless absolutely necessary. IMPORTANT! Cooling system must be deaerated and filled at the rate of 19 [l/min]. 5.8.8. CLEANING THE RADIATOR Remove all bugs and dirt from the radiator core, using air or water under pressure. Direct the flow through the core, opposite to the normal direction of air flow (from outside the coolant level sight gauge, Fig. 5.10). The following should be cleaned: ⁿ oil cooler, ⁿ the air conditioner cooler (if equipped). In CE version clean also the transmission oil cooler. To gain the access to the cooler, the radiator grill must be lifted up (Fig.

5.48A). 5.9. DRIVE AXLES 5.9.1. CHECKING THE OIL LEVEL WARNING: Before working under the machine, block the tires to prevent machine movement. Both the differential and axle oil levels are checked at the filler plug on the axle (the front axle plug is located at the rear left, and the rear axle plug is located at the front right). 1. Position the machine on level ground. Apply the parking brake and block the tires. Let the machine sit long enough for the oil to level out in the planetary and housing. 2. Remove the filler plug on either the front or rear axle. The oil must reach the lower edge of the plug hole. Add lubricant until it starts flowing from the hole.

Refer to “REFILL SPECIFICATIONS AND CAPACITIES CHART” for the type of lubricant specified. Fig. 5.13. Axle Level and Filler Plug 3. Install the filler plug. DRESSTA OM515C520C99/1E