MAINTENANCE SECTION 5 Page 37 ENGINE Fig. 5.27. Engine Valves 1. Suction Valves 2. Exhaust Valves 6. Install the valve covers and torque to 24 [Nm]. NOTE: Refer to ENGINE OPERATION AND MAINTENANCE MANUAL for more detailed instructions of valve lash adjustment. 5.12. ETHER INJECTOR PRECAUTIONS WARNING! Ether starting fluid is highly flammable. Follow strictly the precautions on the container. An explosion can result if sparks or flame contact the ether or if the container is stored where the temperature exceeds 70 [°C]. 1. Do not use the ether injector when the air temperature is above freezing (0 [°C]). 2. Do not smoke when using ether starting fluid. 3.
Do not store fluid containers in the operator's compartment. 4. Keep the fluid containers out of reach of children. 5. Do not breathe the hazardous ether vapor. 6. Do not let ether contact you skin, because it can cause frostbite. 7. Never puncture the fluid container or put it into a fire. Dispose of empty containers properly. 8. For your safety, remove the ether container when welding, grinding, or using a torch on the machine. NOTE: Improper starting fluids can cause valve seizure and severe damage to the engine. Consult an authorized distributor for the recommended starting fluid to be used. IMPORTANT:
The ether starting valve inlet must be sealed against the entry of dirt at all times by having a container installed or by installing the dust cap provided with the valve. INSPECTION AND CLEANING Make certain that ether is available under pressure. To do so, remove the ether container and check if a good spray is obtained. If not, replace with a new container. If a good spray was obtained. Install the container and test the ether injector as follows: DRESSTA OM515C520C99/1E